Testimonials

I bought an old 1976 Corvette - you couldn't imagine all the rusty parts this thing had on it! A friend of mine gave me a can of Free All. Those rusty corroded parts were no match for this magic stuff! No need to get the blow torch out!

— Mike "Meatball" Artale, Lakewood, Ohio

I drive a ’95 Jeep 2.5L and the 1-1/2 bolt on the manifold is known to need a torch to loosen or it will either bust or not come off at all. I sprayed on some Free All, left it sit a few minutes and turned it off like it was new. Your product worked great!

— Jason Abbey, Wayland, New York

Free All made a believer out of me! One of my maintenance mechanics brought me a shaft with a sheave he could not get off - he broke a bearing puller while trying. We sprayed Free All on the sheave and shaft and went to lunch, joking that if this stuff were any good we shouldn’t even need a puller to get it off. When we got back, I put my hands around the sheave and pulled it right off! I have used several different penetrants in the past, but nothing seems to compare with Free All.

— Bob Imgrund, Maintenance Supervisor, Acrometal Company, Inc

I have used several similar products but none have impressed me like Free All – especially on exhaust and other fasteners. Great product. I wish this stuff was around years ago. It would have saved a lot of busted knuckles.

— William Gross, Valparaiso, Indiana

While working at a Sears store we had an air handler that had a fan shaft go bad on a very large cast iron squirrel cage fan that had been in service for over 20 years. After two cans of WD-40 and 3 hours of work, we couldn't get the shaft to budge. The next morning, I sprayed some Free All in the hub holes, smacked a board against the shaft end 3 times, and that shaft went flying through the fan hub and out the other side. My partner just looked at me and asked if I had bought a can of Free All for him, too. It’s all I keep on my truck.

— Greg Kazian, Greenville, South Carolina Acrometal Company, Inc.

I bought a flooded multipurpose tool and have been trying to restore it to working condition. Rust, bi-metallic corrosion, more rust; you name it. I sprayed some Free All on, came back later, and the previously corrosion-welded parts were practically crawling away from each other. Absolutely amazing result! Thank you for putting out a product that actually does what it claims. Doesn't happen often!

— Tom Gould

I love Free All! I had a pair of rusted cutters that wouldn't even pry apart with WD-40. I sprayed a little Free All on them and was able to open them with one hand. This is the best stuff ever!

— Teiah Hart, Doniphan, Missouri

After spraying a rusted pair of vise grips with many different products, I was ready to give up and throw them away. I sprayed them with Free All and had them working in no time flat. I didn’t have to buy a new pair.

— Frank Koval, Somerset, Pennsylvania

The product does what the name implies. This product does work better than other penetrating oils I’ve used before.

— Ray Demers, Bethels, Connecticut

It just plain works! Rust? Over-torqued? No problem. I used it to prevent galling on stainless to stainless fasteners and it worked great! And you can use it on the interior parts of your car without stinking the place up.

— Jay Shilcutt, Wichita, Kansas

I needed to swap an engine in my 4WD pickup truck and did so using an engine from a front wheel drive car. I had to use the exhaust manifolds from the old engine, so needed to remove those from the replacement. The initial effort to break the bolts loose failed, and I feared I would break them off in the block. I doused the area on and around each bolt with Free-All® and tried again a couple of days later. The bolts turned right out without binding. Free-All® worked far better than the other penetrants I'd previously used.

— Steve Roed, Lino Lakes, MN